Simple Step Stool
This DIY footstep stool is an like shooting fish in a barrel woodworking project which takes minimal endeavor to create a cute piece.
Here's a corking souvenir thought that will draw raves. The joints are accurately made in seconds with a plate jointer, just don't tell your admirers. Yous'll also need a power saw to crosscut the boards and a jigsaw to cut the half-circles in the risers. The lumber you'll need:
- I eight-ft. one×8 clear hardwood lath (actual width is 7-1/iv in. and actual thickness is 3/4 in.). Oak is a good selection considering information technology'southward readily available at abode centers.
- One 4-ft. 1×three hardwood lath (bodily width is ii-1/2 in. and actual thickness is three/4 in.).
Cut the viii-ft. board into:
- Two 22-in. riser boards
- Two 11-in. riser boards
- One 14-in. pace lath
- 1 xiv-in. seat board
Yous'll use 94 in. of the 96-in. board, and then brand practice cuts on a scrap board showtime to check the angle and length of cutting. Don't cut the iii-ft. 1×iii board until you lot've dry out-assembled the step, seat and risers and measured for a perfect fit.
To create two risers, bring together the 11-in. boards to the 22-in. boards with No. 20 biscuits and glue. Allow dry 30 minutes, and so lay the footstep and seat across and marking for two No. 20 biscuits at each joint. Dry-gather the step, seat and risers with biscuits, then cut and snugly fit the crosspieces. Mark the riser-to-crosspiece joint and cut slots for No. 0 biscuits. Glue and firmly clamp the step, seat and crosspieces to the risers. Check for square and let dry thirty minutes, so cut out the iv-1/ii in. diameter arc on the bottom of the risers to create the legs. Cease-sand and utilise your favorite finish. This projection is designed for apply on hard-surface flooring just – non carpeting. We've got plans for lots of different simple stools, like this one that you make using your jigsaw.
Source: https://www.familyhandyman.com/article/simple-step-stool/
0 Response to "Simple Step Stool"
Post a Comment